A Better Way to Handle Your ROQ and M&R Flash Systems
If you’ve ever run an automatic press, you know the flash heater is usually the part that holds everything up. It’s frustrating. If that lamp doesn’t hit the right temperature in a few seconds, your whole line crawls. We got tired of that, so we built replacement lamps specifically for M&R and ROQ systems. We didn’t just look at the wattage on the box; we focused on heat density. Because that’s what actually gets the job done. Getting the power right Here’s the thing: if a lamp doesn’t match your transformer exactly, you’re asking for trouble. Even a tiny mismatch in voltage can either leave your ink tacky or blow the filament out way too early. We spec our tubes to line up perfectly with your existing setup. We also use high-purity quartz glass. Why? Because we want that shortwave infrared radiation to punch straight through the ink and hit the fabric. It’s not about heating up the air around the shirt—it’s about getting the energy exactly where it needs to be. No headaches during install Nobody wants to spend their afternoon rewiring panels or messing with lamp holders. That’s why we use standard R7s or Sk15 connectors. You just pop them in. We also paid a lot of attention to where the tungsten filament sits. It’s positioned to throw heat evenly across the platen. No more annoying cold spots or wondering why one side of the garment isn’t curing. Keeping things running Switching to these lamps is a great way to cut down on maintenance costs without slowing down your production. But there is a catch. High-output lamps put a lot of pressure on your reflectors. If yours are pitted or looking dull, you’re wasting energy. Keep them polished, or you’re leaving performance on the table. These lamps are built to take a beating. They can handle the constant on-off clicking of a 24/7 production run without flinching. Just do yourself a favor and keep those cooling fans clear of lint. When you’re pushing this much heat, you need every bit of airflow you can get.